7
Operating Instructions
KEY PAD FEATURES
MODE
A uto
A uto
68
Temp / Timer
Control
Check
Filter
Mode
Selector
Energy
Saver
LED
Display
Auto
Timer
Sleep
Mode
Fan
Speed
Power
Button
POWER:
Turns unit On/Off.
MODE:
Allows you to scroll through and select the desired operating
mode:
NOTE: The unit will automatically launch the Energy Saver function when it is
in Cool, Dry, and Auto modes (only Auto-Cool and Auto-Fan modes).
Cool , Dry , Fan Only and *Auto. The selected mode will be denot-
ed by the adjacent indicator light. * ‘Auto’ is
a pre-set factory program
that
automatically defines the mode (Cool or Dry) and fan speed,
based on the
set temperature. The unit will automatically launch the Energy Saver function
ENERGY SAVER:
Automatically cycles the fan on and off while the
compressor is not in use. This function is available in Cool, Dry, and Auto
TEMP / TIMER CONTROL:
Used to increase or decrease
the Temperature setting in 1°C / °F increments, and Auto-Timer On/Off set-
tings in 30min./1hr. increments.
Note:
This appliance allows you select the
temperature scale to be displayed in either “Celsius” or “Fahrenheit”
according to your preference.To change the temperature scale displayed
on the electronic display, press both the “Temp/Timer”adjust arrows simul-
taneously to alternate between “Celsius” & “Fahrenheit”.
CHECK FILTER:
The adjacent indicator light will illuminate as a
been cleaned and replaced, depress the Check Filter button in order to
resume operation.
AUTO-TIMER:
Used to initiate the Auto On/ Auto Off timer.
While the Air Conditioner is off (Auto-On):
1)
Press the Auto-Timer button once and the adjacent Auto-On indicator
light will illuminate.
2)
Use the Temp/Timer control cursors to select a delayed On time of
up to 24 hours.
3)
Select the appropriate mode under which you want the unit to operate
(Auto-Cool-Dry-Fan Only)
4)
Select the fan speed setting.
5)
The time you selected will appear in the LED display.
modes (only Auto-Cool and Auto-Fan modes). The fan will continue to run for
3 minutes after the compressor shuts off. The fan then cycles on for 2
minutes at 10 minute intervals, until the room temperature is above the set
temperature. At this point, the compressor turns back on and cooling starts.
SLEEP MODE:
In this mode, the selected temperature will increase
LED DISPLAY:
Displays the following information independently - Set
Temperature, Ambient RoomTemperature and Auto Timer On/Off settings.
FAN SPEED:
Select from four different fan settings: Low , Medium,
High and Auto during Cool and Fan Only mode.
Please
note,
during ‘Dry’
mode the fan speed is automatically defined.
reminder to clean the air conditioner filter (see page 14). Once the filter has
(when in cooling mode) by 2°F one half-hour after Sleep mode has been
selected. The temperature will then increase by another 2°F after an addi-
tional half hour. This new temperature will be maintained for 6 hours before
returning to the originally selected temperature. This ends the Sleep mode
and the unit will continue to operate as originally programmed. The Sleep
mode program can be cancelled at any time during operation by pressing the
Sleep button again.
