22
GEAR UNITS WITH “D” TYPE SHAFT
Dana Incorporated
IMM-0005EN Posiplan (MT-5215-0806)
Disassembly:
remove the anchor bolt (pos. 6) from its relative seat. Insert 2 bolts (pos. 7) into the two threaded holes on the backplate (pos.
3) and screw them until they touch the machine shaft (pos. 1). Now give them alternately one full turn each (see Fig. 15).
GEAR UNITS WITH “D” TYPE SHAFT
MACHINE SHAFT WITH SHOULDER:
Assembly:
Lubricate the coupling seat (pos.9) on the gear unit female shaft (pos. 2), then take the coupling andinsert it into its seat without
tightening the bolts.
Align the axes of the gear unit female shaft (pos. 2) as much as possible with the machine male shaft (pos. 1), then bring the
two shafts together.
Slot them together without exerting too much pressure on each part.
To make sure the female gear unit shaft is tight against the machine shaft use a threaded rod (pos. 4) of an appropriate size.
Now insert the inner seeger retaining ring (pos. 5) then the backplate (pos. 3). Now when you tighten the threaded rod, the two
shafts will abut against each other (see Fig. 16).
Fig. 14
Fig. 15
Fig. 16
6
3
5
3
7
5
1
2
9
3
4
