D'Amore Engineering AMM-1, Руководство пользователя

Страница: 14 / 16

14
Dyno Mode
In this mode the AMM-1 will act like our AD-1 Amplifier
Dyno. The highest True Power reading during a "run"
will remain on the display. The power reading is
compensated for both Power Factor and clipping of the
signal.
How to use Dyno Mode
1. Power on the AMM-1 by pressing the ON button
2. Unit will power up, display internal battery condition,
and then land on the DC Voltage Screen.
3. Press the MODE button six times (or hold down) to
get to the Dyno Power screen.
4. Shut off AC source (amplifier)
5. Disconnect one of the wires from the load of interest
(subwoofer)
6. Run the either the negative or positive speaker wire
through the hole on the center of the AMM-1, and
reconnect the wire to the load. (Doesn't matter
which one, but only use ONE of them)
7. Connect the voltage harness to the banana jacks
and then to the amplifier speaker outputs (+) and (-)
8. Power up AC current source (amplifier) and apply a
signal with a tone generator or tone CD at a low -
moderate volume level
9. The AMM-1 will display the True Power in Watts,
compensated for both clipping and Power Factor.
10. Now grab your volume knob and roll it up until you
see the red Clipping LED illuminate.
11. The AMM-1 now displays the maximum clean True
Power in Watts (RMS).
12. To reset the reading press the CLEAR (On) button
for 1 second.