Dalsa Pantera TF 6M8, Руководство пользователя, Страница: 24 / 68

24 Preliminary Pantera TF 11M and 6M User’s Manual
DALSA 03-32-10096-03
3.5 Setting the Data Mode
The PT-2x-11M04 and the PT-2x-06M08 have two output taps, each are 12 bits. The 24 bits
of data (two taps) that are sent from the camera to the frame grabber are divided into
three ports: A, B, and C. Each port is 8 bits. The
sos
command selects the number of bits
that the camera sends to the frame grabber from each tap. In the table below, ports A-C
refer to the Camera Link specification.
To set the data mode for the camera output, use the command:
Syntax:
oms i
Syntax Elements:
i
14
14 bit
Tap 1 Data bit 0 to 7 are linked to Port A
Tap 1 Data bits 8 to 13 are linked to Ports B bits 0 to 5
Tap 2 Note: When operating in 14 bit mode, tap 2 cannot be
transmitted as normal. To maintain the same frame rates as
when the camera is configured using 2 taps (command
sos
2
), the dual tap data is piped to a single tap. The output
pixel rate increases to 72Mhz and the framegrabber uses the
same configuration used for one tap operation. (Refer to
section 3.4 Setting Output Mode command for setting the
number of taps.)
12
12 bit (Factory setting),
Tap 1 Data bits 0 to 7 are linked to Port A
Tap 1Data bits 8 to 11 are linked to Port B bits 0 to 3
Tap 2 Data bits 8 to 11 are linked to Port B bits 4 to 7
Tap 2 Data bits 0 to 7 are linked to Port C
10
10 bit,
Tap 1 Data bits 0 to 7 are linked to Port A
Tap 1 Data bits 8 and 9 are linked to Port B bits 0 and 1
Tap 2 Data bits 8 and 9 are linked to Port B bits 4 and 5
Tap 2 Data bits 0 to 7 are linked to Port C
8
8 bit,
Tap 1 Data bits 0 to 7 are linked to Port A
Tap 2 Data bits 0 to 7 are linked to Port B
Notes: •
To obtain the current output data format, use the command
gcp
Example:
oms 8