DIS-2/M StreamerPro HDD Large UTP
29
Dallmeier electronic
9
Network settings
To avoid network conflicts, you should clarify whether the intended changes are permitted
before you change the network settings. In particular, the allocation of an IP address that
has already been used may result in malfunctions.
9.1
General settings
The basic network settings are made in the Network settings dialog.
NOTE
After the network settings have been changed, the connection
to the DIS-2/M StreamerPro HDD Large UTP is broken. You
then have to log in again.
¾
Select Common settings > Network ....
¾
First select the appropriate Link speed for the current LAN. In most cases the default
setting automatic will suffice.
If you check the DHCP option, you will connect to the existing network without any further
configuration. No other information (IP address, etc.) must be entered. In this case the
module takes its network settings from a central DHCP server.
If DHCP is not selected, enter the IP-Address for the module and also the Netmask and
the Gateway.
¾
Save your settings by clicking on OK.
¾
Log back on to the system.
Fig. 9-1