LFE input
A
A
B
B
C
3.2 Installing and Switching On
NOTE
If the subwoofer
in use has no
dedicated LFE input,
connect the output
of the WSR to the
subwoofer’s standard
line input and either
switch its low-pass
filter to bypass or
set its low-pass
filter frequency to
maximum.
Begin your DALI WSR installation process by
following the steps below.
•
Ensure that the subwoofer is switched off. If the
subwoofer has no power switch, we recommend
that it is disconnected from mains power while
WSR connections are made.
•
Use the supplied RCA Phono cable to connect
the output socket of the WSR to the LFE
input socket of the subwoofer
A
. The output
socket of the WSR is highlighted in Diagram 2. If
necessary, refer to the subwoofer user manual
for identification of its LFE input socket.
•
Connect the WSR power supply to a mains
socket and then connect the power supply to the
WSR using the USB power cable supplied
B
.
The WSR will switch on immediately. The WSR
USB power socket is illustrated in Diagram 2.
•
Switch on the subwoofer or reconnect it to mains
power
C
. If the subwoofer is fitted with a volume
control, we recommend it be set to around 25%
of full volume.
DIAGRAM 2
Reset button
6
