11
5.4 POWER
The POWER button is the main ON/OFF switch. We recommend switching OFF the subwoofer when
it is not to be used for extended periods. When the POWER button is set to OFF there will still be
voltage inside the subwoofer. If you completely disconnect the subwoofer from the mains voltage,
please be sure to remove the mains plug from the subwoofer. When changing connections, always
disconnect the mains voltage from the subwoofer. We recommend that you ALWAYS turn OFF the
IKON MK2 SUB on the rear side of the subwoofer BEFORE turning off the mains switch.
5.5 ON/STAND BY
The subwoofer has a built-in circuit that will power up the amplifier of the subwoofer when an
input signal is detected (given that the POWER is set to ON and the power mode switch is set to
AUTO). When the subwoofer is ON, the ON/STANDBY LED will light green. If an input signal is not
detected for approximately 20 minutes, the subwoofer will go into standby mode and the ON/
STANDBY LED on the rear of the subwoofer will light red.
6 . 0 R U N N I N G - I N
You should expect the sound quality from your new subwoofer to gradually improve during the
initial period of use. Nothing particular has to be done in order to run in the subwoofer – but expect
up to several hours of playback (depending on playback level) before full performance level is
reached. Use normal music for running-in the subwoofer.
7 . 0 O V E R L O A D I N G
If DALI IKON SUB MK2 is overloaded, the built-in safety circuit may power down the subwoofer.
The subwoofer will power on again when the temperature of the built-in amplifier is within safe
working range.
If overloaded, we recommend that you turn off the subwoofer for a few minutes before turning it
on again.
NOTE:
The built-in safety circuit is no guarantee against damage as a result of overloading.
8 . 0 M A I N T E N A N C E
Cleaning the subwoofer surfaces can be done with ordinary household cleaning agents and using
a micro fibre cloth. Avoid using products that are abrasive or contains acid, alkali or anti-bacterial
agents. Avoid using aerosols. Avoid using cleaning agents directly on the drive unit and clean this
with extreme care.
8.1 AVOID DIRECT SUNLIGHT
The surfaces of the subwoofer may fade or become discoloured over time when exposed to direct
sunlight. Therefore avoid positioning the subwoofer in direct sunlight.
9 . 0 D I S P O S A L
DALI products are designed to meet the international directives concerning Restriction of Hazardous
Substances (RoHS) and disposal of Waste Electrical and Electronic Equipment (WEEE). The waste
symbol indicates that the speakers meet the directives (see Figure 2). The subwoofer must be
processed or recycled appropriately. Please consult your local waste authority for guidance.
