DMX-T4-ZONE
Controller Touch
Manuale Dispositivo
Made in Italy
Rev. 2020-12-15
Pag.
3
/
4
DALCNET S.r.l, Registered office: Via dei Laghi, 31
–
36077 Altavilla Vicentina (VI)
–
Italy
Headquarters: Via Lago di Garda, 22
–
36077 Altavilla Vicentina (VI)
–
Italy
VAT: IT0423100235
–
–
➢
Key functions
Each zone can correspond to a single-color, dual-color (WW/CW), RGB, RGBW, or RGB+CCT(WW/CW) controller or lamp.
To enter the zone light setting:
1.
Tap the power button to turn on the light,
2.
Press the power button again to turn off the light.
3.
Hold down the power button immediately for 5 seconds,
4.
As soon as I enter the setting, press 1/2/3/4 Zone to set them.
For example, if you want to change the light type of zone 1 as an RGB type, press the Zone 1 button for 2 seconds for a long time, and then press
indicator
for 2 seconds, doing so sets Zone 1 as RGB type.
If zone 1 indicator is set like this: we'll only have one color to set
If zone 1 indicator is set like this: Double color to set
If zone 1 indicator is set like this: RGB to set
If zone 1 indicator is set like this: RBGW to set
If zone 1 indicator is set like this: RGB+CCT to set
If you want to change zone 2/3/4, press the Desired Zone button for 2 seconds, then repeat the steps described above.
Short press on the ON/OFF button or on the color wheel or waiting for time-out 10 seconds, you will exit the area light type setting.
The short pressure turns on the zone light and selects the zone at the same time. Press 2s for a long time to turn off the zone light.
There are 4 separate or synchronous zone controls, each zone could control multiple receivers.
Only multiple zones with the same light type can be selected synchronously.
Turn the light on or off
One touch starts 10 dynamic models, a touch of 2 sec. starts a mode-
cycle
RGB/Color Temperature
Press RGB or CCT to change from RGB to CCT
One tap to repeat scenes. Long press for 2 sec. saves the color in the
scene. Recall the 4 scenes or save them in sync.
24-level RGB
Adjust the brightness, one touch set 10 levels of brightness, pressing for
1-6 sec adjust the brightness up to 256 levels continuously.
For double colors or RGB+CCT(WW/CW), adjust temperature with
WW/CW channels. A short press set 11 levels of tunable white, if
pressed for 2 seconds sets the maximum or minimum color temperature
available in the channel.
For RGB adjust the temperature color doing a mix on R G B channels;
can set 11 tunable white levels.
For RGBW adjusts the brightness of the W channel, until 11 levels. A
longer tap of 2 seconds brings the brightness of the White channel to
100% or 0%.
RGB mode: with a short touch it sets up to 10 levels of colour rotation
speed, keeping the button pressed for 2s goes to the default speed.
For static RGB colour, adjust the saturation, i.e., short pressing the
button slowly changes the current static RGB colour to white up to 11
levels, instead long pressing for 1-6s adjusts continuously the colours up
to 256 levels.
