DALBO MAXIROLL 530, Руководство пользователя

Страница: 35 / 39

MAXIROLL
Side 35
Mounting of axle with roller rings.
1. Place the axles with roller rings and bearings in a position that is similar to
that of the MAXIROLL when it is unfolded and resting on the ground.
2. Unfold the MAXIROLL and carefully tilt down to the axle.
3. Replace the bolts (A).
Never allow bystanders within the operating radius of the implement when/if the
hydraulic system is activated.
Changing the middle axle
Fig. 32
1. Loosen the bolts (A).
2. Activate the tilting cylinders and tilt MAXI-
ROLL until the wheels are resting on the
ground and the bolts are loose.
3. Remove the bolts.
4. Tilt the MAXIROLL until the wheels are lift-
ed off the ground again, as high as they
can move.
5. The axle with the roller rings can be rolled
away from the roller.
6. Mount in reverse order.
Never activate the hydraulic system when there are bystanders within the operat-
ing radius of the implement.
Changing axle, bearings or roller rings
Fig. 33
1. Loosen the set screws in the bear-
ings and slide the bearings (A) off
the axle.
2. Loosen the screws in the collars.
Slide off the collars (B).
3. The roller rings can be taken of the
axle.
4. Mount in reverse order.
5. Apply Loctite to the set screws in
the bearings.
 Tighten and loosen the screws in the collars several times to make sure that they
are tight on the axle.
3
B
A