DALBO MAXICUT 260 Series, Руководство пользователя

Страница: 24 / 32

MAXICUT
Page 24
Replacements and repairs
Safety is crucial regarding all repair work on MAXICUT. The following items must
therefore be observed at all times, as well as the items under safety at the beginning of
the instruction manual.
Any maintenance and repair work on MAXICUT must only be carried out when the
machine is lowered to the ground or is set in transport mode, the break on the tractor is
applied, the engine is switched off and the ignition key is removed, so that the machine
cannot move or start accidentally.
For all repair work on the hydraulics, always pay close attention to safety. Before the
work is started, release the pressure in the hydraulics system and, if necessary,
support the part.
Once the repair work on the hydraulics system is complete, the system must always be
vented before use to prevent mechanical breakdown and personal injury.
They must never be persons within the operating radius.
Hydraulics
Changing the tilt cylinder
Repairs conducted on MAXICUT should be unfolded and laid down on the ground.
Fig. 10
The pressure is removed from the tilting cylinder (A).
1. The hoses are mounted on the cylinder
2. The cylinder is supported
3. The nail splitters are installed while the nails are uninstalled.
4. The cylinder can be uninstalled
5. New or repaired cylinders can be installed
A