DALBO FRONTFLEX 450, Руководство пользователя, Страница: 7 / 27

FRONTFLEX
Page 7
•
Hydraulic connections must be carefully cleaned before connecting. When connecting
the hydraulic hoses to the tractor unit's hydraulic system, ensure that the hydraulic
pressure is released.
•
After repair work, bleed the hydraulic system thoroughly.
•
Check hydraulic hoses regularly for defects such as cracks, slits, wear and tear or break-
age. Replace defective hoses immediately.
•
Avoid oil splashes and oil spillages on the ground. If this happens, clean up the
splash/spillage and dispose of it.
•
Clean your hands thoroughly after the skin has come into contact with any oil or grease.
Changed any oil-soaked clothing immediately as it is harmful to the skin.
•
Hydraulic oil escaping under high pressure can penetrate the skin and cause serious
injuries. Consult a doctor immediately in the event of injuries.
Assembly
•
There is a risk of crushing during installation. No persons must stand between the ap-
paratus and the tractor unit or between components that are coupled together.
Maintenance and repairs
•
Support the machine must well or fold the machine out for all repair and maintenance
work. Apply the tractor unit and machine brakes safely, switch off the engine and re-
move the key.
•
Tighten all screw connections after the machine has been in operation for a few hours.
Check all screw connections regularly and tighten them as required. Check split pin
rings and bolts to prevent accidents.
•
Dispose of any oil and grease in accordance with the applicable environmental regula-
tions.
Road transport
•
When driving on public roads, all legally prescribed safety and warning devices must be
installed and approved. The driver is responsible for proper lighting and labelling in ac-
cordance with the applicable road traffic law.
•
With regard to the destination of the machine, the driver must check with the transport
authorities that it may be transported on public roads.
•
When transporting the machine, you must ensure that you do not exceed the maximum
weight and axle load of the tractor unit and that the load on the front axle of the tractor
unit is not less than 20
%
of the unladen weight of the tractor unit.