Daktronics Tuff Sport H-2101, Руководство пользователя

Страница: 26 / 82

20 Scoreboard Troubleshooting
Replacing a Driver
If the driver status indicators do not appear to be working correctly, it may be necessary to
replace the driver.
1. Open the digit panel or scoreboard face panel as described in Section
‎
5.2 .
2. Disconnect all connectors from the driver by squeezing together the locking tabs and
pulling the connectors free.
Note: It may be helpful to label the cables to know which cable goes to which
connector when reattaching the driver.
3. Remove the wing nuts securing the driver to the driver tray.
4. Carefully lift the driver from the display and place it on a clean, flat surface.
5. Position a new driver over the screws and tighten the nuts.
6. Reconnect all power/signal connectors.
Note: The connectors are keyed and will attach in one way only. Do not attempt to
force the connections.
7. Ensure the driver is set to the correct address (refer to Setting the Driver Address ).
8. Close and secure the access panel, then power up and test the scoreboard to see if
changing the driver has resolved the problem.
Setting the Driver Address
Since the same LED drivers can be used for many
scoreboard models, each driver must be set to receive
the correct signal input, or address, for the model being
used. This address is set with jumper wires in a 12-pin
plug which mates with jack J19 on the driver (
Figure 13 ).
It may be possible to reuse the same address plug from
the driver that was replaced. If not, first refer to the
specifications table in
Section 2 to find the correct driver
address(es) for a particular scoreboard model. Then
refer to
Drawing A-115078 in Appendix A for a listing
of the wire/pin connections for driver addresses 1 – 128.
Multiple Drivers
Scoreboards that require multiple drivers operate using a master/slave driver configuration.
Master and slave drivers function identically, but slave units lack the power/signal
termination blocks. The two drivers have been designed to simply plug into one another, and
this is done at the factory, so no additional on-site connection is necessary.
If it appears as though only a certain group of digits on the scoreboard is not functioning,
there may be a problem with the slave driver(s) or the power/signal connection from the
other driver(s).
Figure 13: Address Jack J19