Daktronics TI-2041, Руководство пользователя

Страница: 5 / 34

Introduction
1
1 Introduction
This manual explains the installation and maintenance of Daktronics TI-2041 and TI-2042
pitch time displays. For additional information regarding the safety, installation,
operation, or service of these displays, refer to the telephone numbers listed in Section 5:
Daktronics Exchange and Repair & Return Programs (p�13) . This manual is not specific
to a particular installation.
Important Safeguards
• Read and understand all instructions before beginning the installation process�
• Disconnect the display power when not in use or when servicing�
• Disconnect the display power before servicing power supplies to avoid electrical
shock� Power supplies run on high voltage and may cause physical injury if touched
while powered�
• Do not modify the structure or attach any panels or coverings to the display without
the express written consent of Daktronics�
• Do not disassemble control equipment or electronic controls of the display; failure to
follow this safeguard will make the warranty null and void�
• Do not drop the control equipment or allow it to get wet�
Specifications Label
Power specifications as well as serial and model number information can be found on an
ID label, similar to the one shown in Figure 1 .
ASSY NO.
SER. NO.
MFG DATE
BROOKINGS, SD 57006-5128
PHONE 800-325-8766
LL-2306 R01
201 DAKTRONICS DR.
DAKTRONICS
Figure 1: Specifications Label
Please have the assembly number, model number, and the date manufactured on hand
when calling Daktronics customer service to ensure the request is serviced as quickly as
possible. Knowing the facility name and/or job number will also be helpful.
Resources
Figure 2 illustrates a Daktronics drawing label.
This manual refers to drawings by listing the last
set of digits. In the example, the drawing would
be referred to as DWG-1007804 . All references to
drawing numbers, appendices, figures, or other
manuals are presented in bold typeface. Any
drawings referenced in a section are listed at the
beginning of it as shown below:
Reference Drawings:
System Riser Diagram ....................................................................................... DWG-1007804
Daktronics identifies manuals by the DD or ED number located on the cover page.
Drawing Number
Figure 2: Drawing Label