Daktronics ST-3170, Руководство пользователя, Страница: 8 / 50

Uncrating
4
2 Uncrating
Use a pry bar to carefully remove the side panels of the crate, and then remove the top
of the crate. Each crate may contain one, two, or three tables.
Attach Caster Bases
1� Locate a caster base assembly under the table. Each table has two caster base
assemblies regardless of width.
2� Use a utility knife to cut through the plastic wrap around the caster base assembly.
Refer to Figure 4 .
Figure 4: Remove Plastic Wrap from Caster Base
3� Lift the Caster Base Tool (attached by lanyard) off of the caster base assembly and
set aside. Refer to Figure 5 .
Figure 5: Remove Caster Base Tool
4� Holding the caster base steady with one hand, slip a couple fingers of your other
hand under the caster base pivot arm and lift up until it is fully extended. Refer to
Figure 6 .
Figure 6: Lift Pivot Arm