Daktronics ST-3170, Руководство пользователя, Страница: 27 / 50

Electrical Installation
23
End-of-Period and Clock Stop Light Strip Kits
Reference Drawings:
Light Strip Attachment ..................................................................................... DWG-4889870
Daktronics scorers tables may have optional End-of-Period (EOP) light strips running
along the bottom front of the table that illuminate at the end of the period. Tables may
also feature Clock Stop light strips along the rear cable tray. EOP light strips are typically
factory installed, while rear Clock Stop light strips must be installed on site using clips and
screws as described in DWG-4889870 .
1� Set the All Sport
®
control console on the tabletop
and plug the power cord into one of the rear
convenience outlets.
2� Connect the 10’ (3 m) 1/4" phone signal cable (part
# W-1340) from J1 , J2 , or J3 on the control console
to the SIGNAL IN jack located behind the right rear
access door of the primary table. Refer to Figure 40 .
Note: For the Clock Stop light strip, plug the 3-pin
XLR cable into the rear CLK STOP OUT jack
just above the tabletop. Refer to Figure 41 .
Store excess cable in the cable tray
beneath the top pad.
3� For multiple tables with light strips, connect 3' (0.9 m)
3-pin XLR cables (part # 0A-1313-0114) from the XLR
outputs to the XLR inputs between the tables.
• The
EOP OUT and CLK STOP OUT jacks are
located behind the left rear access doors as
shown in Figure 42 .
• The EOP IN and CLK STOP IN jacks are located
behind the right rear access doors as shown in
Figure 40 .
4� Power on the control console and enter the appropriate sport code
found on the keyboard overlay and in the All Sport
®
manual listed in
Light Strip Controllers (p�3) to test the light strips.
Figure 40: Light
Strip Inputs
Figure 41: Rear
Clock Stop Jack
Figure 42: Light
Strip Outputs