PPX-1050 Series Panel Installation & Service Quick Guide
Page 1 of 3
DD5004860
Rev 00
05 January 2022
201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
Basics
Display Accessories
Standard display accessories include the following:
• Lifting tool
• Key
• Power input cable
• Signal input cable
Figure 1:
Lifting Tool
Figure 2:
Key
Figure 3:
Power Input Cable
Figure 4:
Signal Input Cable
Storage & Shipping
Panels are stored and shipped in
wood crates with four panels per
crate. The depth of the crate is
980 mm, and the height and width
vary by panel size. Refer to the table
Crate Size
Panel Size
940x1240 mm
640x1120 mm
940x1400 mm
640x1280 mm
1100x1240 mm
800x1120 mm
1100x1400 mm
800x1280 mm
Figure 5:
Wood Crate
980 mm
940 or 1100 mm
1240 or 1400 mm
Mechanical Installation
Panel Installation
Note:
Two people are required for the steps in this section.
1.
Use a pry bar to remove the crate lid, exercising caution to prevent
damage to the LED panels in the crate. Refer to
Figure 6:
Remove Crate Lid
Figure 7:
Remove Crate Side
2.
Use a pry bar to remove the crate side, exercising caution to prevent
damage to the LED panels in the crate. Refer to
3.
Use the supplied lifting tool as an additional handle and remove the
panel from the crate. Refer to
Figure 8:
Remove Panel from Crate
Figure 9:
Stand Panel on Ground
4.
Use the side handles on the panel to stand the panel upright on the
ground. Refer to
.
5.
Verify the existing jump cable on the panel is a female-to-male
Figure 10:
Female Connector
Figure 11:
Male Connector
6.
Use the supplied key to unlock the top locks and slide the top cover
back to remove the cover. Refer to
Figure 12:
Unlock Top Locks
Figure 13:
Remove Top Cover
7.
Use the lifting holes to lift the panel. Refer to
.
Figure 14:
Lift Panel
8.
Repeat
Steps 3-7
for any additional panels.
45°
minimum
Figure 15:
Lift Panel
