Daktronics Galaxy GS6, Инструкция по установке и эксплуатации

Страница: 14 / 47

Signal Cable Installation
10
6 Signal Cable Installation
For specific details on installing the communications, consult the quick guide and manual
included with the communication equipment. Each type of communication is listed
below with its document number.
Communication Type Communication Manual Communication Quick Guide
Wireless Ethernet Bridge DD1685027 DD1417586
Ethernet DD1417609 DD1417573
Fiber Ethernet DD1417611 DD1417581
These are the standard communication types, but each site is unique and may include
additional equipment. If problems arise, contact the display's service company or
Daktronics Customer Service.
Primary/Mirror Display Interconnections
For data to get from the Primary display to the Mirror
display, the fiber interconnect cable must be connected.
This cable typically comes attached to the rear of the
display.
1� Locate cable and unpackage.
2� Connect one end of the cable to J34 on the rear of
the Primary display. Refer to Figure 12 .
3� Connect the other end of the cable to J32 on the rear
of the Mirror display.
4� Coil up any excess cable and secure it to prevent
vandalism and weather-related damage.
Note: Anchor points are found on each fan hood for securing excess cable.
Sectional Display Signal Connections
For sectional displays, data is transmitted from one section to the next through fiber
cables connected to the outside of each section.
Each section has multiple jacks labeled either A or B. Refer to DWG-3141399 for correct
cable routing between display sections. A label on the rear of the display also illustrates
how to connect the cables.
Figure 12: Signal Out Jack