Galaxy GS6 Display Internal Connection
Conversion Quick Guide
1 May 2017
DD3497847
Rev 02
201 Daktronics Drive Brookings, SD 57006
www.daktronics.com/support
800.325.8766
Page 2 of 2
9. Connect the cables to the jacks on the quick-
connect plate.
Reinstall Modules
Move the J-Box to Display’s Interior
1. Remove two bottom-left modules to access
the J-box location.
2. Pull wires from J-box into display cabinet.
3. Use a channel lock or socket wrench to loosen
the nut holding the J-box in place.
4. Attach the metal tabs found inside the J-box
to the corners of the J-box. Find the screws
needed to attach the tabs also inside the
J-box.
5. Place the J-box inside the display making sure
to align it with the existing J-box hole on the
display’s backsheet.
6. Use
1
/
4
″ Tek screws (screws not provided) to
secure the J-box inside the display on the
backsheet.
7. Route electrical wires from the term panel to
the J-box.
8. Attach
3
/
4
″ conduit to the back of the J-box.
9. Or seal the hole using on of the plugs found on
the J-box so no water can enter the J-box and
attach
1
/
2
″ conduit to one of the knockouts on
the back of the display. Inside the cabinet,
route wires from the knockout into the J-box for
termination.
10. Attach J-box cover.
Reinstall Modules
