Daktronics Galaxy AF-3155, Руководство пользователя

Страница: 25 / 87

Installing an RJ Connector
Installing an RJ connector on the end of the conductor
cable is a simple task when the correct tools are used.
The RJ11 crimping tool (Daktronics part number TH-
1033) performs two separate steps.
Figure 17: Wire with Outer
Jacket Stripped
First, use the crimping tool to strip the outer insulation
from the inner wires. This does not result in bare wires
since only the gray outer jacket is removed. After correct
stripping, the wire will appear as shown in
Figure 17
on
the right.
The crimping tool is then used to crimp the RJ connector onto the cable. The RJ
connector is locked into a special socket in the tool. The stripped wire is inserted into
the RJ connector. Finally, the tool is squeezed like a pliers to crimp the connector
onto the wire. This completes the installation of an RJ connector onto the wire.
3.4 Conduit
Reference Drawings:
Shop Drawing; AF-3155-**x***-20mm-RGB ................ Drawing B-184075
Daktronics does not include the conduit. Refer to Drawing B-184075 for
approximate locations for power and signal conduit. Separate conduit must be used
to route:
•
Power
•
Signal IN wires
•
Signal OUT wires (if signal is required for another display)
Note: Quick connect cables from display to display do not need to be in conduit.
Knockout holes for ½" conduit are located at the bottom right (rear view) of the back
of the display (refer to
Drawing B-184075 ).
For displays with more than one face, and when not using the quick connect
interconnect cable, signal and temperature sensor wiring between displays can be
routed through the same conduit.
Electrical Installation
3-5