Daktronics FUELIGHT FL-3000 Series, Руководство по установке и эксплуатации

Страница: 15 / 60

Cash/Credit Display Installation
11
Display Identification
Identify 2H x 2W cash/credit
modules by their position when
viewed from the front. Refer to
Figure 20 .
Figure 21 shows the identification
used for an alternate size 1H x 2W
display.
Install the Display
A rectangular opening must
be provided to accommodate
the Cash/Credit display. Refer
to the Shop Drawing for cutout
dimensions.
1� Remove existing displays.
2� Provide a rectangular opening in the sign structure to
accommodate the Cash Credit display. Refer to the
Shop Drawing for cutout dimensions.
3� Lift displays into the sign structure. Figure 22 shows a
display being inserted into a sign structure.
4� Drill through the front flanges of the cabinet to attach
the display to the base structure using appropriate
hardware for site conditions. Refer to Figure 23 .
Actual site demands will dictate variances and
appropriate mounting methods.
Figure 23: Secure Display in Sign Structure
5� Repair and seal any unused openings in the sign structure.
Note: Openings greater than 1/2" (12.7 mm) in diameter require a metal patch
secured by screws or rivets and caulked with non-hardening caulk. Smaller
openings may be sealed with non-hardening caulk.
Access Internal Components
The door of Cash/Credit displays is secured by a screw (two screws secure the door on
2H displays).
1� Use a Phillips-head screwdriver to loosen the screw.
2� Open the door using the knob attached to the display face.
3� The power supply is attached inside the cabinet to the display’s backsheet, as shown
in Figure 24 , and its location varies between display sizes.
Top Left Top Right
Bottom Right
Bottom Left
Figure 20: 2H2W Display Identification
Left Right
Figure 21: 1H2W Display Identification
CORNER GAS
REG
DSL
UNL
Figure 22: Inserting Display Into
Cabinet