Fuelight
TM
FL-3000 and FL-4500 Petroleum
Display Installation Quick Guide
DD2238842
Rev 08
06 February 2019
201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
Page 4 of 4
3.
The power supply is attached inside the cabinet to the display’s backsheet, as shown in
,
and its location varies between display sizes.
Grounding
Cash/Credit displays do not require a local earth ground electrode.
The displays still require a safety ground from the electrical service panel for the primary power wires to
comply with national electric codes.
Cash/Credit Display Power Installation
Install Daktronics Cash/Credit displays using a two-wire plus
ground circuit. The ground from the circuit must be connected
to the grounding stud within each Cash/Credit display. Do not
connect neutral to ground at the disconnect or at the display,
this would violate electrical codes and void the warranty.
Use a disconnect so that all ungrounded conductors can be
disconnected.
To connect power to the display, complete the following steps:
1.
Route power cable into the display through one of the
knockouts on the display’s backsheet.
2.
Use wire nuts or other appropriate hardware to connect
power wires to the power supply harness or pigtail. Refer to
.
3.
Connect supply power ground wire to the grounding stud.
.
Note:
Verify the power supply ground wire is connected to
the grounding stud.
Connect Cash/Credit Display to the Fuelight Driver
Connect the 8 position Mate-N-Lok plug of harness W-2709 from
the cash/credit module to jack J18 on a Fuelight driver. Refer to
Use
Grounding
Stud
SERIAL #
LABEL B
LABEL A
LABEL C
Figure 12:
Internal Component Locations
Figure 13:
Power Connection
Figure 14:
Cash/Credit Display
Connection to Driver
