Daktronics FB-2700 Series, Руководство по установке, Страница: 26 / 60

Electrical Installation
22
Radio Settings
With an All Sport radio receiver or RC-200
base station installed, watch for the radio
Broadcast settings (“b1”) and Channel
settings (“C1”) in the clock digits or Home
and Guest scores during the Power-On Self-
Test (POST) (p�20) . Refer to Figure 24 .
These values must match the settings in the control console/scoring app. Refer to the
controller screens below and the manual listed in Display Controllers (p�2) .
If the radio receiver channel and broadcast settings do match those set in the console/
scoring app but the display still cannot be controlled, there may be radio interference.
This can occur when a nearby display also uses radio control. In this case, change the
settings of the wireless radio receiver inside the display as described in the appropriate
controller or radio installation manual.
Note: Models BA-2027, BA-2127, BA-2028, and BA-2029 with radio control will have two
radio receivers: one for the main scoreboard, and one for the speed of pitch
digits. Both receivers must be set to different channels.
Power/Signal Connections Between Sections
Refer to the component location drawings attached to the product specification sheets
listed in Appendix A for exact driver locations when connecting multiple display sections.
Two-Section Models
Open the appropriate access panel on the Top Section to locate the coiled bundle
of interconnect cable coming from the driver, then route and connect the cables as
described below and shown in Figure 25 . Additional panels may be opened as needed
for easier access.
Route the 5-pin interconnect cable from the Top Section down into the Bottom Section;
connect the P42 plug into the J42A jack on a Y-cable coming from the Primary Driver.
DAKTRONICS
HOME GUEST
QTR
DAKTRONICS
HOME GUEST
QTR
All Sport / RC-200 / DAK Score
RC-100
Figure 24: Radio Settings in Clock Digits
RADIO SETTINGS
BCAST 1 CHAN 01 GROUP (1-8): 01
CHAN (1-8): 01
All Sport Radio Settings RC-200 Radio Settings
DAK Score App Settings
Top Section
Bottom Section
(Power & Signal Terminated
in this Section)
(Coiled Interconnect Cable
Located in this Section)
Primary
Driver
P42
J42A
Figure 25: Power/Signal Connection – Two Sections, Excluding BA Models (Front View)