Daktronics FB-2700 Series, Руководство по установке, Страница: 20 / 60

Electrical Installation
16
Figure 17 illustrates a wireless setup between a football scoreboard and controller. Note
that the RC-200 handheld controller and base station system is typically only available for
use with smaller single-section displays and for single- or multi-court tennis scoreboards.
DAKTRONICS
QTR DOWN TO GO
BALL ON
HOME GUEST
ALL SPORT MX-1
TX
Status
Power
Internal
Power/Signal
Interconnect
(Multi-Section
Models Only)
Power Terminated
Inside Cabinet
Through Rear
Lockable
Power
Distribution /
Disconnect
To Main Power Source
- See Specfications
Grounding Rod
Grounding Wire
Concrete
Footings
All Sport
Controller
with Radio
Option
OR
OR
RC-200
Handheld
Controller
MX-1 Interface Box
Up to 1500' away with
direct line of sight*
*Max 500' Away
Radio Receiver OR
Base Station Mounted
Behind Face Panel
Figure 17: Wireless Installation Example
For additional installation examples, such as for multi-court tennis systems, refer to the
System Riser drawings attached to the controller manual listed in Display Controllers
(p�2) .
Power
Only qualified individuals should complete the electrical installation; untrained personnel
should not attempt to install these displays or any of the electrical components� Improper
installation can seriously damage the equipment and be hazardous to personnel�
Refer to the specification label on the display ( Figure 1 ), the label inside the display
( Figure 19 ), or the product specification sheets shipped with it (and listed in Appendix A )
to determine maximum power requirements. Ensure all external overcurrent protection
meets all local and national electrical codes and is appropriately sized to the load it is
terminating. Failure to meet wiring and overcurrent protection device requirements will
void the warranty.
Note: Ensure the display is on a dedicated circuit. This will prevent loss of critical game
event information that may otherwise occur if another component on the same
circuit should fail.