DVX-1830 Series Sectional
Installation Quick Guide
28 November 2016
DD3396953
Rev 00
201 Daktronics Drive Brookings SD 57006
800.325.8766
www.daktronics.com/support
Page 4 of 8
Center Adjustment
Corner blocks provide proper spacing at the ends of section seams,
but spacing may vary in the middle where the sections come together.
Additional holes are provided along both the horizontal and vertical edges
of the cabinet for further adjustment if required. Install hardware in these
locations only if further seam adjustment is required.
For wide center seams, install
1
/
4
″ bolts (located in the blue interconnect
hardware bag) through the holes behind the face sheets at the problem
locations in the bottom of the top cabinet or the left side of the right cabinet
and into the next cabinet’s nutsert. Tighten these bolts until the seam is
within tolerance. Refer to the
DD3008872 DVX-11X2/1502/1801 Series Seam
Measurement Field Instructions for details on seam tolerance and to Figure 11
for details on seam adjustment.
For tight center seams, install
1
/
4
″ bolts (located in the blue interconnect
hardware bag) into the pre-installed nutserts behind the face sheet at the
problem locations in the bottom of the top cabinet or the left side of the right
cabinet. Tighten the bolts until the seam is within tolerance. Refer to the
DD3008872 DVX-11X2/1502/1801 Series Seam Measurement Field Instructions
for details on seam tolerance and to Figure 12 on page 4 for details on
seam adjustment.
Figure 11:
Adjusting Wide Center
Seams
Figure 12:
Adjusting Tight Center
Seams
