Daktronics DistaView BA-624-31, Руководство пользователя, Страница: 29 / 96

Electrical Installation 4-3
4.2 Power and Signal Connection
Reference Drawings:
Schematic; DistaView OD LED Multi-driver Display .... Drawing A-229706
Driver; GEN IV LC Outdoor LED, 16 Col ..................... Drawing A-285469
Driver; GEN IV LC Outdoor LED, 8 Col ....................... Drawing A-285470
Schematic; XFMR 8 Col, GEN IV, DistaView LED ...... Drawing A-285892
Schematic; XFMR 16 Col, GEN IV, DistaView LED .... Drawing A-286657
Schematic; XFMR 16 Col, GEN IV, Outdoor Driver ... Drawing A-704861
All power and signal wiring terminates at the termination connector
TB1
, as
illustrated in
Drawing A-285892
and
A-286657
.
To gain access to the termination connector, open the access door and remove the
cover from the enclosure. Refer to the component locations drawings for the access
location for your scoreboard.
Connect power and signal cables at the appropriate locations on the termination
connector
TB1
, shown in
Drawing A-285892, A-286657
,
A-229706
and
A-704861.
Note: The TB1 termination connector has protection variators across the terminals
labeled “signal” to the terminal labeled “ground.” For more information, refer to
Drawing A-285892, A-286657, A-229706, and A-704861..
For signal cable, Daktronics recommends, as a minimum, single-pair, shielded cable,
22 AWG (Daktronics part number W-1077). Two-pair shielded cable (Daktronics
part W-1614) is preferred.
For additional information on signal connection, refer to the All Sport 5000 Series
control console operation manual, ED-11976 .