Daktronics BA-2009, Руководство пользователя

Страница: 25 / 120

Clamping to Verticals
Figure 8 , below, illustrates a no-weld, clamping method for the baseball
scoreboards. For additional mounting details, refer to Drawing A-89234.
Mount the scoreboard as follows:
1. Determine where to drill the holes in the rear flanges of the
scoreboard perimeter extrusion. Drill
9
/
16
" holes in the extrusion on
either side of the vertical beam, within 1" of the outer edge of the
beam. Use the pre-drilled holes in the clamping angle as a guide.
Position the holes from the edge of the perimeter extrusion so that
the square nut will fit into the channel (approximately 1" from the
outer edge).
2.
Attach the threaded rods and mounting angles using
1
/
2
" hardware,
and tighten securely.
Attach the threaded rods and mounting angles using
1
/
2
" hardware, and tighten securely.
Figure 8: Scoreboard Mounting, Clamping Method
Mechanical Installation 3-7