Daktronics 65 P2210, Руководство по обслуживанию

Страница: 7 / 31

Introduction
3
Remove A Module From The Spare Parts Rack
1� With one hand on the module face, insert the
1
/
8
″ hex
head wrench into the bottom access hole.
2� Turn the latch release approximately a quarter-turn
counterclockwise. You should feel the module release
from the module bracket.
3� Disconnect the SATA cables from the back of the
module.
4� Remove the plug inserted into the power jack, as
shown in Figure 5 . Store the plug and cable in an area
free of debris for future use with replacement modules.
Field Replaceable Units
The table below lists component names and part numbers of components that can be
replaced in the display and the control system. Some of these components are located
in the spare parts rack. Contact the ASM to order components when needed.
Display FRUs Control System FRUs
Description Daktronics Part Number Description
Daktronics Part
Number
Module 20MT 16MT Meraki Router A-4036028
Without Gasket 0A-1842-5003 0A-1982-5003 DMP-8000 Player
(Market)
0A-1987-0011
Surge Suppressor A-3732
DMP-8000 Player
(Lamar)
0A-1987-0012
480W Power Supply A-3448678 DMP-8000 Player (CCO) 0A-1987-0013
400W Power Suppl 0A-2133-4005 VIP-5160.2 0A-1603-8401
3 Pole Contactor A-3157 Light Sensor - MDLS 0A-1690-4000
Axial Fan .4 A 115 Volt B-3505432
Ethernet Switch
(Market)
0A-1853-1200
12 VDC Relay K-1040
Ethernet Switch (Lamar
and CCO)
A-2249
28" SATA Cable W-2885 500 W Heater 0A-1690-2900
72" SATA Cable W2889 Mobotix Webcam 0A-1853-4605
Line Filter Z-1007
Mobotix Webcam
(Fisheye Lens)
0A-1604-4646
Term Panel - 20 Amp
Single Pole Breaker
S-1045
SmartLink
TM
(U.S./Can./
Mex)
A-3707
Term Panel - 15 Amp
Breaker
S-1035
SmartLink
TM
(120V
International)
A-3189335
Figure 5: Remove Plug From
Power Jack on Spare Module