Daktronics 6000 Series, Руководство по установке, Страница: 5 / 31

Introduction
1
1 Introduction
This manual provides information to install and fire up a Daktronics digital billboard.
Please read and understand all steps in this manual before beginning the installation
process. Contact the Project Manager with questions.
Limitation of Liability
Failure to perform the following may void factory warranties:
• Install the digital billboard according to the steps in this manual
• Provide proper electrical service
• Ground the display properly
For the full Daktronics Warranty and Limitation of Liability, refer to
Section B: Daktronics
Warranty and Limitation of Liability (p�27) .
Note: This applies to initial installation only. Manufacturer does not warranty relocation
of displays.
Important Contact Information
Daktronics Help Desk: 1-877-DAK-HELP (325-4357)
Display Identification
This section provides information
that is helpful in understanding a
Daktronics digital billboard display
label. Refer to Figure 1 while
reading the table below.
Display Assembly Number
Display Serial Number
Manufacture Month/Date Year
DB-6000 Modules High X Modules Wide
RMN: Daktronics - 0200 - 11 Manufactured in Sioux Falls, SD
120/240 VAC, Single Phase, 60 HZ
AMPS (L1/L2) = 25.5/24.4 Total
Total Watts = 5,979
6000 Series Improvements
Component Improvement Image of Change
Mounting
• Standard offset extrusion
mount
SmartLink
• Located externally on third
door from right
Figure 1: 6000 Series Display Label