Daktronics 6000 Series, Руководство по установке, Страница: 24 / 31

Control System Overview
20
9 Control System Overview
The control components are
enclosed in the display.
Fully Embedded
Control System
Daktronics 6000 series digital
billboards have three major
components. The ISP enclosure
is located behind the third door
from the left. Find the DMP-8065
behind the fourth door from the
left. The SmartLink
TM
is mounted
on the third door from the right.
Display back sheets are labeled with
component locations to make finding
components easy. The table below
describes each the control system
in more detail. Refer to Figure 33 ,
Figure 34 , and Figure 35 while reading
the component descriptions below.
Component Function Number
Thermostat
Measures the temperatures inside the ISP enclosure and turns on
the fan or the heater as needed.
1
Heater
Since ISP equipment is affected by lower temperatures, a heater
prevents the ISP enclosure from going below a functional range.
2
Fan
High heat can damage some electronics, the fan cools the ISP
enclosure to keep the equipment in a safe functional range.
3
Laptop and Cell
Phone Outlet
Can be used to charge laptop or cell phones. Do not plug drills or
other power tools into this outlet.
4
Door Switch
Detects if the ISP enclosure door is open. If opened, an alert will
be created and the content will switch to predetermined content. 5
POE Ethernet
Switch
Connects network devices and provides webcam power. 6
Z-Filter
Suppresses electrical noise in the electrical line. 7
DMP-8065
Converts content data from the Internet into a format recognized
by the display and sends it out to the PLRs in the display.
8
SmartLink
TM
Remote power reboot device. Four relays control the following
components:
• Relay 1 - ISP equipment
• Relay 2 - DMP-8065
• Relay 3 - Display
• Relay 4 - Auxiliary components
Note: Do not cycle relays on site. Call the help desk to cycle the
relays.
9
10
Figure 33: SmartLink
TM
8
Figure 34: DMP-8065
1
2
3
4
5
6
7
Figure 35: ISP Enclosure