Daktronics 4200 Series, Руководство по установке

Страница: 13 / 39

9
Section 3: Display Installation
This section provides general guidelines for DB-4200 display installation. Work closely with the Project
Manager on all installations. Do not modify the display or control system in any manner without the
written permission of the Project Manager as any unauthorized modifications may null and void the
display warranty.
3.1 Display Installation
1. Using a utility knife, carefully cut away all of the white packaging material from the display
and the spare parts box. Pay special attention when cutting around the Multi-Direction Light
Sensor (MDLS) to avoid cutting cables. If possible, do not cut anywhere along the display
face as it can damage the LEDs and modules.
2. Remove the wood and the wood braces from the top of every display section.
3. Lift the spare parts box off of the trailer and set in a location near the installation site as it
contains tools, parts, and documents used for the installation process.
4. Open the spare parts box and verify all installation tools and installation hardware were sent
with the display. Contact the Project Manager immediately if missing installation parts.
5. Verify that the lift-eyes are installed and the lift-eye bolts and set bolts are in place. Refer
to
Figure 3. The lift eye spacing is set at Daktronics and should not be moved without the
Project Manager's permission.
Angle must be
greater than 55°
L
Lift-Eye Bolts
Set Bolts
Tag Line
Tie Off
Top of Display
Horizontal Splice Tube
(From Top)
Vertical
Splice
Tube
Display Lift From Back
Display Lift
From Front
Figure 3: Display Lifting
Display Installation