Dakota TURF TENDER 410, Руководство владельца/оператора

Страница: 11 / 48

11
2. While wearing gloves and safety glasses, hold the longest
free side of each band; then carefully cut each of the
bands (as close as possible to a corner) securing the hopper
to the skid.
CAUTION
The bands are under tension. Wear gloves and
safety glasses. Cut as close as possible to a corner
while holding the longest free side of each band.
3. Insert the Dakota Lift Bar (p/n 11361) beneath the sides
and rear lip of the hopper.
4. Lift the hopper straight up until clear of the pedestal on
the skid. Hold securely until ready to place on either the
vehicle or hopper legs.
WARNING
Do not allow anyone beneath the raised hopper.
5. Remove the two front legs and two jack legs from the
skid.
6. Lift hopper just high enough to insert the front legs into
the receivers on the front cross member beneath the
fenders.
7. Insert the jack legs (with jack handles facing outward)
into the receivers at the rear of the hopper. Secure the
jack legs with the quick pins provided.
8. Set the hopper down onto the legs; then remove the lift
bar.
MOUNTED-TYPE 410T TURF TENDERS
WARNING
Do not allow anyone to work beneath an elevated
lift frame unless a safety bar is in place on one or
both of the lift cylinder shaft(s). For the John Deere
ProGater, install the standard John Deere Safety
Bar. For the Toro Workman, install the DAKOTA
Safety Bar.
NOTE: The Safety Bar may be stowed above the
standard Toro Safety Bar.
NOTE: Prior to mounting the Turf Tender 410T on
the Toro Workman, it is required to install the proper
Auxiliary Hydraulic Kit. Order the proper kit
(gasoline or diesel engine) for your machine; then
using the installation instructions included with
each kit, install the kit.
Removing Components From Skid
1. To avoid damage, transport the hopper/skid carefully.
SETUP