Finger tighten as much as possible, then snug the nuts a bit more with a pair of
needle-nose pliers.
Caution: do not over tighten!
5. Finally, you can attach the
R Handle
. This one requires a few more steps, as follows:
6. Remove Serial Number cover from the
R Handle
. Make sure
the
Rubber Grommet
is in place and that the bundled wires are
protected by the grommet. Slide grommet into slot on R-
handle's electronics cover. Now gently put R-handle into
position, align back studs into slots on bracket. Make sure
grommet is still in position before proceeding.
7. Next, while holding onto the
R Handle
, start the
two hex-head bolts in front (repeat
Step 4
).
Tip:
a second person may be helpful for aligning and
holding the handle while you start the two bolts.
Tighten with 7/16” wrench.
8.
Attach #6
nuts on back. (Same as S
tep 4
). Finger tighten.
(605) 847-4713
(605) 847-4713
44136 200th St.
44136 200th St.
4/6
www.dakotagrills.com
www.dakotagrills.com
Lake Preston, SD 57249
Lake Preston, SD 57249
