10. Attach the
L Handle
. First, slide the back of the handle into the
L Lid-Stop Bracket
.
Line up the two threaded studs with the slots on the lid-stop bracket and slid the
handle back. Attach the front of the handle to the front of the
Grill Body
using two
hex-head bolts, as shown.
Tip: you may want a second person to line everything up
while you start the two bolts; they can be a bit tricky to start otherwise. You might
also find it easier to tip the grill onto its Right Side.
Tighten both bolts. Now start a
#6 nut on each of the studs on the back of the handle, as shown. Finger tighten as
much as possible, then snug the nuts a bit more with the included wrench tool (5/16”)
or a pair of needle-nose pliers.
Caution: do not over tighten!
11. Finally, you can attach the
R Handle
. This one requires a few more steps, as
follows:
12. Make sure the
Rubber Grommet
is in place and that the bundled wires are protected
by the grommet. Slide grommet into slot on R-handle's electronics cover. Now
gently put R-handle into position, align back studs into slots on bracket. Make sure
grommet is still in position before proceeding.
(605) 847-4713
(605) 847-4713
44136 200th St.
44136 200th St.
6/8
www.dakotagrills.com
www.dakotagrills.com
Lake Preston, SD 57249
Lake Preston, SD 57249
(Hex Head
Bolts)
(Front
)
(Left)
(Back)
(Left)
