Manual # 650371E
2. Fasten the three included mounting tabs to the VHX system.
Attach the tabs marked with
“L” and “R”
labels to the left and right sides of the speed and tach gauges
respectively. This will require the four included
6-20 x ½
”
pan head screws
. Insert the screws into the
slots on the back side of the system, directly behind the mounting tabs. Partially tighten these screws
for now, do not fully torque them down yet.
The remaining unlabeled tab goes on the bottom left side of the system, between the satellite gauges.
Making sure the countersunk side of the tab is facing away from the rest of the unit, fasten this tab to
the VHX system with the two included
6-20 x ¾
”
flat head screws
. This tab can be tightened until flush.
4.
Attach the CAT5 cable to the VHX cluster and the two harnesses to use the stock blinker location if so
desired. This system comes with two options for the turn signals in your dash. You can either have arrows
located in the faceplate of your new VHX display, and/or arro
ws in your vehicle’s stock turn signal locations.
To use the new faceplate arrows, follow the wiring instructions for the turn signals found in the main VHX
manual.
1 of 2
3. Due to differences in bezels, there is some adjustability built in to the VHX system. Test fit the VHX display to
your bezel and align the top to the guides in the slots. When satisfied with the fitment, tighten the screws.
1. First, remove the 10 screws holding the bezel to the dash. Remove the stock instrument cluster, making
sure to retain the four original instrument cluster screws for mounting the Dakota Digital VHX system later.
Installation
“R” Tab
“L” Tab
Unlabeled Tab
