MAN#650274A
6. Pass the gray ribbon cable through the original speedometer gauge
opening, to the rear can. The gauge assembly will fit down inside of the can.
Two pairs of aluminum hex standoffs are used to position the system at the
proper angle, the lower pair will line up with screw holes in the can and be
used for retention, while the upper pair is used for support only.
7. Use the two supplied silver, #6-32x.250” screws in the holes marked
with the red arrows as shown in the photo at right.
Use the two supplied black, #6-20x.500”, self threading screws in the
holes marked with the yellow arrows as shown in the photo at right. Do
not over tighten these screws as you may strip out the holes in the plastic
they thread into.
8. Install the bezel and either re-crimp the edge or use silicone to
attach it back onto the can.
See the main instruction manual for the remainder of the
installation.
WARNING:
This product can expose you to chemicals including lead, which is known to the State of California to
cause cancer and birth defects or other reproductive harm. For more information go to
