MAN#650129A
4
Saving and Setting Presets
Each button on the button panel represents a preset height. The three user
programmable heights can be changed or set as many times as desired. Follow the steps
below to set the heights.
Use Manual down (buttons 1 & 2) or Manual up (buttons 2 & 3) to move the motors to
the desired height.
Once at the desired height, press and hold the button that you wish to save the current
height to for about 2 seconds.
The other buttons will flash indicating that the position has been saved
Release buttons and repeat the above steps for the remaining buttons
NOTE:
To move to a preset, push and release a button. The motors will move
automatically to the preset height for that button. If a button is pressed while moving to a
preset height the motors will stop at the current height.
Single Motor Adjust
The single motor adjust can be used if the linear actuators are not traveling at similar
speeds and the trunk/cover is stopping slightly crooked.
This should only be done if the
trunk or cover is crooked, improper adjustment of a single motor could cause damage
to the vehicle. Also, if the motors differ in set travel by too much, it may cause an
error when attempting to move to a preset.
To adjust motor 1:
Move to the desired position (one of the 3 preset heights)
Turn SWITCH 4 ON and SWITCH 5 OFF
Use the Manual Up/Down to match m
otor 1’s height to the height
of motor 2
Once the motors are at the same height press and hold the current height preset
button to save m
otor 1’s height
(this will only save the new position for motor 1)
Turn SWITCH 4 and 5 back ON (or OFF if auto reverse is disabled) to resume normal
operation
The next time this correct preset position is moved to one motor may run a slightly longer so
the trunk/cover stops at a level height.
To adjust motor 2:
Move to the desired position (one of the 3 preset heights)
Turn SWITCH 4 OFF and SWITCH 5 ON
Use the Manual Up/Down to match mo
tor 2’s height to the height
of motor 1
Once the motors are at the same height press and hold the current height preset
button to save m
otor 2’s height
(this will only save the new position for motor 2)
Turn SWITCH 4 and 5 back ON (or OFF if auto reverse is disabled) to resume normal
operation
NOTE: The single motor adjust should only be done if the linear actuators are stopping and the trunk/cover
is crooked. Improper adjustment could cause damage to the vehicle. The system will not move to a preset if
switches 4 and 5 are not both ON or OFF. Switches 4 and 5 have to both be ON or OFF for the preset heights
to work, or only a single motor will move with the manual up/down commands.
