4
MAN # 650466
SETUP:
ENTERING SETUP:
1. The supplied switch must be connected to the switch connector on the back of the gauge.
2. Press and hold the switch while turning on the motorcycle key, powering up the gauge.
3.
The screen will display “SETUP”. Release the switch to enter the setup menu.
USING SETUP MENU:
4. Press and release the switch to move through the different setup menu options.
5. To select a menu option, press and hold the switch until the screen changes.
6. Press and release the switch to change the setting if desired (unless noted otherwise below).
7. Press and hold the switch to save the setting (unless noted otherwise below).
8.
Display will show “DONE”. Release the switch to return to main menu.
EXITING SETUP:
To exit the setup menu, select “EXIT” from the main setup menu. Alternatively, the key may be turned off while in
the main setup menu.
NOTE: If the key is turned off while in a menu option changing settings, the displayed setting will not be saved.
The setting that was previously stored will be used on next power up.
SETUP MENU:
CONTRAST
Allows adjustment to the LCD screen contrast
(See “SETTING CONTRAST” below for switch function)
SET HOUR
Sets hour offset from UTC (Coordinated Universal Time) from GPS
FORMAT
selects between 12hr (2:34 PM) and 24hr (14:34) time formats
UTC-11hrs to UTC+12hrs
sets hour offset from UTC for your local time zone (will need to be adjusted
when time goes from daylight savings time to standard time or vice versa).
DISPLAY
Sets function of lower information display area
ALTIMETER
will display only the altimeter (height above sea level) in lower information section
CLOCK
will display only the clock in lower information screen
ALT / CLK TOGGLED will toggle between altimeter and clock every 2 seconds
COLOR
Selects backlight color of gauge from 8 colors
STOCK
Color designed to appear like the color of lighting in stock gauges
GREEN
– CYAN – BLUE – MAGENTA – WHITE – RED – YELLOW
additional colors
BRIGHTNESS
Sets the backlight brightness
0-31
Backlight brightness. 0 dimmest, 31 is brightest.
TEMP UNIT
Sets the unit used to display temperature reading
F
temperature is displayed in Fahrenheit
C
temperature is displayed in Celsius
ALTIM UNIT
Sets the unit used to display altimeter reading
FT
altimeter reading is displayed in feet
M
altimeter reading is displayed in meters
INFO
Displays system information (may be needed for troubleshooting or tech support)
Press and release switch to change screens, Press and hold to return to main menu.
Available data: signal strength readings, speed in MPH, firmware version, and time.
RESET
Resets all settings back to the factory presets
RESET ALL SETTINGS Y/N
asks you to verify selection of reset
EXIT
Leaves the setup menu
