MOUNTING
A mounting bracket must be purchased for your application. Some of the current brackets are: BKT-5001 1” bar
mount, BKT-5002 flat triple-tree mount, BKT-5003 35° triple-tree mount, BKT-5004 1-1/4” bar mount, BKT-5005 1-
1/2” bar mount, and BKT-5006 1” riser bar mount. The bar mount brackets can be used for above-the-bar
mounting or below-the-bar mounting. The 35° triple-tree mounts are only available for above-the-bar mounting.
The triple-tree mounting bracket replaces the original handle bar mount. The gauge attaches to the back side of
the bracket with the supplied screws.
The bar mount brackets have a curved front bracket and two rear brackets. The longer screws attach the gauge to
the back side of the bracket and the shorter screws go into the recessed openings on the rear brackets. The mount
fits tight and will need to be pulled together by the screws.
To mount the gauge under the bar:
1. Remove the rear plate by unscrewing the four screws.
2. Remove the rubber cap from the switch.
3. Flip the rear plate over so the mounting tab is on the top. The hole for the switch should stay on the
same side.
4. Place the switch through the hole and replace the rubber cap.
5. Reattach the rear plate using the four screws.
6. Place bar mount bracket on the handle bars so that the recessed screw holes are on the top.
7. Using the long screws, secure the gauge to the bottom side of the bar mount bracket.
Drawings for using bar mount brackets above the bar and below the bar.
Remove and reverse
back plate for under-bar
mounting.
