3. Specification
Parts of the electric fence energizer system
Model S1600 S4000
Range Up to 1.6km Up to 4km
Power source 12V, 4AH, 12V, 4.5AH rechargeable lead-acid battery
Maximum output Voltage up to 8.1KV up to 8.3KV
Voltage under 500ohm up to 2.5KV up to 3KV
Energy 0.11 J 0.3J
Stored energy 0.16 J 0.4J
Unless otherwise stated, values are typical and normal production tolerances of
±
10% should be
allowed for
4. Installation guide
Installing the battery
Caution! When connecting the battery, be careful not to short-circuit the supply terminals.
Positioning the energiser
Install the energizer adjacent to the electric fence, preferably in the middle of the electric fence in
a position where it will receive the most sun, ideally in excess of 6 hours of full sun a day. Its
1 ON/OFF/Night mode switch
2 DC charging input
3 Earth output terminal.
4 Locking hole
5 Star Post mount
6 Fence output terminal
7 Locking hole
8 Solar panel
9 Battery
10 Battery box
11 Battery box fixing hole
1 Place the energizer on a flat surface.
Open the battery compartment using a
screwdriver (see diagram below).
2 Insert the battery.
3 Connect the positive (red) lead to the
positive (+) terminal on the battery.
4 Connect the negative (black) lead to
the negative (–) terminal on the battery.
5 Close the battery compartment.