- 4 -
CLEANING
1. Remove anti-rust oil.
2. Remove the coating with a clean brush applied with appropriate solvent.
3. When the coating has been softened, remove it with clean rag.
POWER SUPPLY
1
.
Shut off the main power switch
before connecting cable
.
2. Check motor voltage against
supply voltage
.
3. Make sure the power supply is
connected to comply with the
local safety regulations.
4.
Your saw may be pre-wired with
a power cable attached. This
cable can be hard wired or the
preferred method of installing a
properly rated quick disconnect.
▲
WARNING
All electrical connections must be done by
a qualified electrician. Failure to comply
may cause serious injury!
All adjustment or repairs must be done with
the machine disconnected from the power
source. Failure to comply may result in
serious injury!
5. The leads connect to L1, L2, and L3 and ground. The bandsaw must be grounded.
6. Check that the blade is running in the correct clockwise direction. If the blade runs
backwards, disconnect the power. Then reverse any two of the three L1, L2, and L3
leads. Do not reverse the ground.
SPECIFICATIONS
Capacity
15 ½” X 10”
Blade Width Cap.
1/8” ~ 5/8”
Blade Speed
82-3,950 fpm
Table Size
21.5" x 24"
Table Tilt
R-15
ﾟ
, L- 12
ﾟ
, 8
ﾟ
Each F & B
Main Drive Motor
230 volt 3 Phase, 2 HP
Grinder Motor
110V, 1 Phase, 0.04 KW
Blade Length
123 ½”
Blade Welder Cap
2.4 KVA,
1/8” ~ 5/8”
Band Wheel Diameter
16”
Table Height
39”
Dimension
37” (Length) 26 ½” (Width) 72” (Height)
Mach. Weight
904 lbs.
