Dake SXC 988040, Инструкция и список запасных частей

Страница: 5 / 16

5 DAKE/PARMA SXC
SXC ADJUSTMENT
A BLADE TENSION HANDLE – Used to remove and install saw blade. Also used to set
the correct blade tension – Be sure blade is tight.
B&C UPPER BLADE WHEEL CONT ADJUSTMENT – If your saw should get out of
adjustment and the blade runs off the wheel or runs back against the lip, loosen the two
bottom bolts on the wheel slide (B) Turn the set screw (C) in or out to make the blade
run approximately
1/32
” away from the lip on the back of the wheel. Tighten the two
wheel slide bolts. IMPORTANT: If the blade is allowed to run against the lip on the
wheel it will wear the lip off.
D GUIDE BAR LOCK – Used to lock the roll guides in position.
E ROLL GUIDES – Should be adjusted so they clear your work by approximately ½”. This
will insure maximum blade rigidity.
F STOP CLAMP – Has two uses: 1) The stop clamp can be set for depth of cut. 2) The
stop clamp, if placed behind the neck, will lock the frame in a forward position for
contour work.
G ANGLE PLATE – Used to hold stock in place for cutting. Graduations are provided to
set angle cuts.
H C-CLAMP – Used mainly for round stock. Flat stock needs no clamping.
I COUNTERWEIGHT – Used to maintain the blade pressure you desire.
J HYDRAULIC CYLINDER – This should be adjusted to allow the frame to travel rapidly
but not free fall. This is a safety device and should be kept properly adjusted.