daisy
pool covers & rollers
Daisy
Saves
Care &
Maintenance
Cover
Installation
Congratulations.
Here’s how to look after your Daisy Pool Cover and Roller.
To ensure receipt of the benefit of this warranty,
complete this section upon purchase and retain with
purchase receipt for production upon warranty claim.
Purchased from:
Please note: Solar pool covers are not safety
covers. They are not designed to support people.
Do not swim under the Cover.
This warranty covers the purchaser for defective
material or workmanship on a pro rata basis as set
out below. The manufacturer will repair or replace
the product upon inspection or photo image.
Daisy reserves the right to refuse repeat claims
of the same damage.
The warranty may be void if:
1 The purchaser fails to comply with the
manufactures installation instructions.
2 Exposes the cover rolled or folded to the sun.
3 Subjects the cover to conditions, which result in
tears, cuts or damage.
4 Stores the cover at a temperature above 45
degrees Celsius.
5 Stores the cover in other than complete shade.
6 Allows the chlorine levels to be maintained at a
higher than normal level.
This is a Pro Rata month by month warranty.
This means that Daisy Pool Covers will pay for the
amount of time that you do not achieve from your
Pool Cover (up to the maximum warranty period). It
also means that you must pay for the period of time
during which you have used the product.
Note - This Warranty is not redeemable for
cash, only as a discount on a replacement
cover purchase.
Product
Pro-Rata Warranty cover
S3
Series 3
(200um) UltraDome TM
3 Years
S4
Series 4
(300um) UltraDome TM
4 Years
S5
Series 5
(400um) UltraDome TM
5 Years
S8
Series 8
(500um) UltraDome TM
8 Years
ThermoTech
3mm Foam
8 Years
Daisy is Australia’s largest supplier of pool covers and rollers.
Call: 1300 551 811 Fax: 1300 885 242
Daisy
Saves
daisy
pool covers & rollers
www.daisy
poolcovers.com.au
Pool Cover Installation
To install your solar pool cover:
1)
Lay the cover
bubble side to the water.
2)
Flatten out all air bubbles so that the cover
sits relatively flat on the water.
3)
Using your pool as a template, take
a pair of ordinary household scissors
(the sharper the better!) and with someone
holding the cover in position, cut the
edge of the cover so that it sits flat on the
water with 50 -75 mm rising up the side
of the pool (but not necessary for the top
edge of the pool).
If required, you can:
A)
Cut the cover back to waterline,
however, wait 2-3 weeks after initial
cut for it to settle down.
B)
Cut two vertical slits in the cover
upturn, either side of your skimmer box,
fold the flap you have created into the
skimmer box, therefore allowing you to hose
debris off the top of the cover into
the skimmer box.
Your Daisy cover is delivered with an
ample margin for trim. In some cases the
excess is sufficient for secondary use and
left for you to use as you see fit.
Because our covers are made of polyethylene
they are category 4 LDPE recyclable.
