(WOS2-CM)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save these instructions for future use.
1
Installation Process
Installation Guide
WOS2-CM | DT108
Risk of electrical shock. Disconnect power before servicing or
installing product.
Install in accordance with National Electric Code and local codes.
WARNING
Risk of injury. Wear safety glasses and gloves during installation and
servicing.
CAUTION
The
Ceiling Mounted Wireless Occupancy Sensor (WOS2-CM)
operates seamlessly within the Daintree Networked platform.
The WOS2-CM is a battery-powered occupancy sensor using
passive infrared (PIR) sensing technology to detect movement.
As part of the Daintree Networked platform and using open,
standards based ZigBee wireless communications, the WOS2-CM
reports real-time occupancy events to turn on lights or keep them
on when movement is detected, and turn off lights when a space
is left vacant. The sensor’s off-delay timer is user-configurable
from any location using the Daintree Controls Software (DCS)
web application, eliminating the need for on-site, manual
sensor adjustment.
The WOS2-CM-S provides the standard coverage area, 500SF
with a 360 degree (lateral) coverage. The WOS2-CM-E provides
an extended coverage area of up to 1000SF.
• Keep the sensor lens clean. Avoid touching the sensor lens.
• After first-time installation or reinstallation of a new battery,
allow up to three minutes for initialization.
1.
Determine the mounting local on for the sensor based on day
light availability and task area. See
Placement
for details.
2.
Remove the sensor from the base by twisting it. Locate the
sensor’s IEEE address on the label inside the base. Record the
sensor’s IEEE address in its local on the facility floor plan.
3.
Attach the mounting base to the ceiling in the specified location.
Be sure the label is visible after mounting the base.
4.
Install the batteries in the orientation (+ -) shown on
the bottom of the battery compartments.
5.
Secure the sensor to the ceiling by twisting it onto the base.
6.
After the batteries have been installed for at least 3 minutes,
initiate the Installation Test Mode: Momentarily press the
Utility button. The green LED flashes once then the red
LED flashes each time the sensor detects motion. (The test
mode times out after 5 minutes.)
Daintree
®
Wireless Occupancy
Sensor, Ceiling Mount
Occupancy
Sensor
Lens
Network LED
(green)
Infrared Detection
&Test Mode LED
(red)
Utility
Button
Base
