Daimler SEATTLE 1343B, Руководство оператора

Страница: 77 / 90

Amerex™ Fire Suppression System
Page 71
2. Trouble Indicator
This indicator light notifies the
operator that there is a fault in
the fire suppression system.
Notify service personnel
immediately.
3. Fire Indicator
This indicator illuminates when
the fire suppression system has
been discharged. When this
conditions occurs, the operator
should halt the vehicle
immediately and evacuate the
bus.
4. Trace Gas Level Indicators
(not applicable)
These indicators illuminate
when small concentration of
gas has been detected. A light
will illuminate in the zone in
which the gas concentration
has been identified. Have
maintenance personnel service
vehicle as soon as possible.
5. Significant Gas Level
Indicators (non applicable)
These indicators illuminate
when a dangerous gas
concentration has been
detected. A light will illuminate
in the zone in which the gas
concentration has been
identified. Suspend all vehicle
operations immediately and
evacuate the bus.
See “Fire
Suppression System” on
page 71.
6. Alarm Silence Indicator
Push to silence audible alarm.
7. System Test Button
Tests LED’s and all electrical
circuits.
8. Relay Reset Button
Pushing this button resets the
relay after gas or fire alarm has
been cleared.
9. Manual Activator
Pushing this button allows the
operator to manually discharge
the dry chemical.
10. Fluorescent Display Panel
Fire Suppression System
A total of six temperature detection
sensors are installed in the vehicle;
four in the engine compartment, one
in the battery compartment and one
in the after treatment compartment.
The temperature sensors are
NOTE
Only when the gas has cleared
and the alarms are OFF can you
press the Relay Reset button to
reset the internal relay.