Daimler SEATTLE 1343B, Руководство оператора

Страница: 42 / 90

Engine Operation
Page 36
ENGINE OPERATION
Pre Start-Up Inspection
Maintenance and Service personnel
are required to perform a daily pre
start-up check to ensure adequate
levels of oil, coolant, and fuel.
Inspect and verify that all safety
equipment is functioning properly,
such as lights, brakes, and tires,
clear windshield, side windows, and
adjust and clean mirrors.
For further information on the
Cummins™ ISB engine, refer to
your Cummins™ ISB Operation and
Maintenance manual.
Starting an Electronically
Controlled Engine
1. Ensure the parking brake valve
is applied and the entrance
door is closed.
2. Place the Master Switch in the
DAY RUN position.
The red STOP ENGINE and an
amber CHECK ENGINE light,
located on the front instrument
warning indicator panel, will
illuminate for approximately 10
seconds for a bulb check.
3. Check all unnecessary lighting
and other controls are switched
OFF.
4. Place the transmission selector
in the NEUTRAL position.
5. Wait for the WAIT TO START
indicator light, located on the
front instrument panel, to
extinguish.
6. Press and hold the ENGINE
START button to start the
engine.
No application on the
accelerator (throttle) pedal is
necessary during start up. The
CAUTION !
Check that the battery voltage is
above 24 volts before starting the
engine. Failure to do so can
result in damage to the starter.
NOTE
The engine is equipped with a
starter interlock protection
feature. This feature allows for a
maximum of 14 second cranking
time.