- 7 -
V. Installation procedures
Each part of the electric treadmill has been strictly assembled and debugged before leaving the
factory. As long as they are installed according to the following steps, an electric treadmill will be
easily installed.
Step I: Installation of upright poles. Lift out the
treadmill and align the left upright pole with the
hole on the left of the chassis and fix them with
2 M8X45 hexagon socket pan head screws, 1
M8X16 hexagon socket pan head screws,
shims and spring washers. Then connect the
right upright pole with the chassis by the control
line inside the upright pole. Next, align the
upright pole with the hole on the right of the
chassis and fix them with 2 M8X45 hexagon
socket pan head screws, 1 M8X16 hexagon
socket pan head screws, shims and spring
washers. Attention: for the convenience of the
electronic meter’s installation, screw up all the
screws on the upright poles in two turns. Don't
tighten them, as shown in the following figure:
Step II: Installation of electronic meter. Connect
the control line of the upright pole with the
control lines at two ends of the electronic meter.
Then plug the two ends of the electronic meter
into the left and right upright poles and fix the
meter frame on the left and right upright poles
with 2 M6X25 hexagon socket head cap screw,
shims and spring washers. Attention: Screw up
all the screws on the upright poles in two turns.
Don't tighten them, as shown in the following
figure: