Daikin VRV FXFSQ25ARV16, Руководство по установке

Страница: 28 / 30

2. Remove the air filter.
Perform the operation in the order (1) and (2).
(1) Pull the ends of the air filter down and remove the
holes of the air filter from the grille protrusions.
(Both left and right sides.)
Air filter Holes Protrusions on grille
(2) Lift the air filter and remove the holes of the air filter
from the protrusions on the upper side of the grille.
(Both left and right sides.)
Protrusions
on grille
Air filter
Lift up the air filter
Holes Protrusions on grille
3. Clean the filter.
Clean the contamination with a vacuum cleaner or wash
it with water.
If the air filter
is extremely
contaminated,
wash it with
neutral detergent
using a soft brush.
After dewatering,
dry the air filter in
the shade.
NOTE
• Do not wash the air filter with water of 50°C or higher.
It may cause decolorization and deformation.
• Do not heat the filter with a fire.
It may cause burning.
• Do not use such as gasoline, benzine, thinner,
polishing powder and liquid insecticide sold in the
market.
It may cause discoloration and deformation.
4. Attach the air filter.
• Attach the air filter in the reverse order mentioned in
the clause 2.
5. Close the suction grille.
Slowly lift the suction grille, and finally, securely fasten it
to the main body of the decoration panel, while pressing
the two knobs.
NOTE
• The straps may be caught when the suction grille is
closed. Before closing the suction grille, ensure that
the straps are not getting out from the side of the
suction grille.
(Good) (Wrong)
Strap
Suction
grille
Strap is getting
out from the
suction grille.
6. Turn off the message “Time to clean filter”
displayed on the remote controller after turning on
the power.
• For details, refer to the operation manual attached to
the remote controller. The indication can be turned
off whether in operation or at stop.
HOW TO CLEAN THE SUCTION GRILLE
1. Open the suction grille.
Simultaneously press the two knobs, slowly down the
suction grille.
2. Remove the straps of the suction grille.
Remove the two straps from the holding parts on the
panel main body to which the straps are attached.
Strap Holding part
Holding
part Strap
3. Remove the suction grille.
Open the suction grille 45 ° and lift it.
Then, unhook it from the place to hook. (3 places)
4. Take out the air filter.
Refer to clause 2 for
“HOW TO CLEAN THE AIR
FILTER”. (Page. 4 )
5
①
②
Place to hook
Hook
5