Daikin UATQ-C Series, Руководство по установке, Страница: 18 / 40

16
TROUBLESHOOTING
SERVICE AND MAINTENANCE
Service Parts Maintenance Procedures
Air Filter - Remove any dust adhering to the filter by using a vacuum cleaner or wash in lukewarm water
(below 40°C) with a neutral cleaning detergent.
- Rinse the filter well and dry before placing it back onto the unit.
- Do not use gasoline, volatile substances or chemicals to clean the filter.
- Clean the filter at least once every 2 weeks or more frequently if neccesary.
Air filter position.
Unit shown in the diagram is UATQ210/240C. Other models shall follow the same method.
Remove filter cover for filter service
For any enquiries on spare parts, please contact your authorized dealer. If any malfunction of the air conditioner unit
is noted, check the following fault conditions and causes for some simple troubleshooting tips.
Problem Causes Action
Unit does not run. Power failure. Press the [ON/OFF] after power restore.
Fuse blown or circuit breaker tripped. Replace fuse or reset circuit breaker.
Power supply wiring phase incorrect. Modify the wiring phase.
Compressor does not operate in 3
min after unit has started. Protection against frequent starting. Wait for 3 minutes for the compressor to
start.
Air flow is low. Filter is filled with dust and dirt. Clean the filter.
There are some obstacles at the air inlet or
outlet of the units. Remove obstacles.
Compressor operate continuously. Dirty air filter. Clean the air filter.
Temperature setting too low. Reset the temperature.
No cool air delivered. Temperature setting too high. Set the temperature lower .
If the fault persists, please call your authorized local dealer/serviceman.
Air Filter Air Filter
1-IM-5RTC-0315(2)-DAIKIN-EN.indd16 16 1-IM-5RTC-0315(2)-DAIKIN-EN.indd16 16 1/14/16 1:56:02 PM 1/14/16 1:56:02 PM