33
Please check again before calling a repair person.
Check again.
Case
Check
The air conditioner does not
operate.
(OPERATION lamp is off.)
• Hasn’t a breaker turned OFF or a fuse blown?
• Isn’t it a power failure?
• Are batteries set in the remote controller?
• Is the timer setting correct?
Cooling (Heating) effect is poor.
• Are the air filters clean?
• Is there anything to block the air inlet or the outlet of the
indoor and the outdoor units?
• Is the temperature setting appropriate?
• Are the windows and doors closed?
• Are the airflow rate and the air direction set appropriately?
Operation stops suddenly.
(OPERATION lamp flashes.)
• Are the air filters clean?
• Is there anything to block the air inlet or the outlet of the
indoor and the outdoor units?
Clean the air filters or take all obstacles away and turn the
breaker OFF. Then turn it ON again and try operating the air
conditioner with the remote controller. If the lamp still flashes,
call the service shop where you bought the air conditioner.
• Are operation modes all the same for indoor units connected
to outdoor units in the
multi system
?
If not, set all indoor units to the same operation mode and
confirm that the lamps flash.
Moreover, when the operation mode is in “AUTO”, set all
indoor unit operation modes to “COOL” or “HEAT” for a
moment and check again that the lamps are normal.
If the lamps stop flashing after the above steps, there is no
malfunction.
(page 27.)
An abnormal functioning
happens during operation.
• The air conditioner may malfunction with lightning or radio
waves. Turn the breaker OFF, turn it ON again and try
operating the air conditioner with the remote controller.
The indoor unit comes to a stop
or does not operate when the
heat pump model is selected.
• Unless the air conditioner has a heating function, the unit in cooling,
dry, or fan operation comes to a stop if the heating mode is selected.
If the heating mode is selected and the Run button is pressed while
the unit is not in operation, the unit does not start operating.
Check the specifications of the outdoor unit. If the outdoor
unit is cooling only model, set the remote controller for a
cooling only model using the cooling only/heat pump switch
on the remote controller. (page 9.)
If you are not sure about how to switch the setting, contact
the service shop where you bought the air conditioner.
The remote controller allows
selection of “heating” even
though the unit is cooling only
model.
Heating cannot be selected,
even though the unit is heat
pump model.
• Set the remote controller so that it is for a heat pump model
by using the cooling only/heat pump switch on the remote
controller. (page 9.)
If you are not sure about how to switch the setting, contact
the service shop where you bought the air conditioner.
01_EN_3P207037-1.fm Page 33 Monday, September 10, 2007 5:16 PM