Daikin SkyAir RZQ-TA Series, Руководство по обслуживанию

Страница: 64 / 291

1DPHVDQG)XQFWLRQV 6L86(
3DUW5HPRWH&RQWUROOHU
12 TIMER MODE START/STOP BUTTON
13 TIMER RESERVE/CANCEL BUTTON
14 AIR FLOW DIRECTION ADJUST BUTTON
15
OPERATION MODE SELECTOR BUTTON
Press this button to select OPERATION MODE.
16
FILTER SIGN RESET BUTTON
Refer to the section of MAINTENANCE in the operation
manual attached to the indoor unit.
17
INSPECTION/TEST OPERATION BUTTON
This button is pressed for inspection or test operation.
Do not use for normal operation.
18
EMERGENCY OPERATION SWITCH
This switch is readily used if the remote controller does
not work.
19
RECEIVER
This receives the signals from the remote controller.
20
OPERATING INDICATOR LAMP (Red)
This lamp stays lit while the air conditioner runs.
It flashes when the unit is in trouble.
21
TIMER INDICATOR LAMP (Green)
This lamp stays lit while the timer is set.
22
AIR FILTER CLEANING TIME INDICATOR LAMP (Red)
Lights up when it is time to clean the air filter.
23
DEFROST LAMP (Orange)
Lights up when the defrosting operation has started.
(For cooling only type this lamp does not turn on.)
1
DISPLAY “ ” “ I ” (SIGNAL TRANSMISSION)
This lights up when a signal is being transmitted.
DISPLAY “ ” “ ” “ ” “ ” “ ”
(OPERATION MODE)
This display shows the current OPERATION MODE.
3
DISPLAY “ ” (SET TEMPERATURE)
This display shows the set temperature.
4
DISPLAY “ ” (PROGRAMMED TIME)
This display shows PROGRAMMED TIME of the sys-
tem start or stop.
5
DISPLAY “ ” (AIR FLOW FLAP)
6
DISPLAY “ ” “ ” (FAN SPEED)
This display shows the set fan speed.
7
DISPLAY “ ” (INSPECTION/ TEST OPERA-
TION)
When the INSPECTION/TEST OPERATION BUTTON
is pressed, the display shows the system mode is in.
M H L
F
hr.
hr.
TEST
2
8
ON/OFF BUTTON
Press the button and the system will start. Press the
button again and the system will stop.
9
FAN SPEED CONTROL BUTTON
Press this button to select the fan speed, HIGH or LOW,
of your choice.
10
TEMPERATURE SETTING BUTTON
Use this button for SETTING TEMPERATURE.
(Operates with the front cover of the remote controller
closed.)
11
PROGRAMMING TIMER BUTTON
Use this button for programming “START and/or STOP”
time. (Operates with the front cover of the remote con-
troller opened.)